(9:00AM to 5:00PM)
This is the all new omnibus F4 Pro, based on the design of the popular omnibus F3 pro. However this main advantage of this board is that is uses the more powerful STM F4 processor for even faster loop times. It has all the other things you love from the Omnibus F3 pro including an OSD module, SD card reader, low noise MPU6000 IMU connected via SPI, a current and voltage sensor etc..
The V2 pro version includes a built in BEC now, so you can power this board directly from your flight battery. (up to 4s)
SPECIFICATIONS
SPI Gyro MPU6000
On-Board OSD (controllered by Betaflight, FC over SPI bus)
MicroSD Blackbox
Baro (BMP280) （default is closed,need to open in configuration，if not know how to open,contact with us）
F4 Processor (F405)
5v3a SBEC
Built-in Current Sensor
On-Board Video Filter (only can supply 5V to VTX and Camera)
USING PPM
Package including:
1 X F4 OMNIBUS V2 PRO Flight Controller w/ pin and servo cable
1 Set Cables
Gold USB board and Silver USB board send at random
Note:If you have trouble geting the FC to recognise your PPM receiver, here is what you need to do. You need to enable RX_serial in the GUI and turn UART3 on. Save and reboot the flight controller. Then re-selecting RX_PPM again on the GUY and the FC now communicates with your PPM receiver
If have difficult of updating firmware or connection,please contact with us without any doubt.
