333
With Intelligent MCU control system,323B lithium battery charger supports to charge the 2S and 3S Li-Po and Life battery.
Specifications:
Input Current: 2500mA/MAX (advise power supply: 12/2A)
Repair voltage: 1.50V-3.00V/CELL
Three charge current: 0.5A, 1.2A, 2.0A
Repair current: 200 mA
Balance of current: 200 mA
Balance of precision: 10mV
Repair bad battery time:1 min
Under voltage protection: less than 10.0V
Over voltage protection: more than 18.0V
Charger instructions: instructions stall charge (3 LED), each cell balanced/charge instructions (3 LED), power supply instructions.
How to use
1. Connect charger and power supply, all LED lights in turn, charging current indicated as 1.2A.
2. Use the right button to choose the charging current.
3. Use the left button to choose battery type. Battery mode must be selected before connected battery and charger.
4. Charge one battery one time.
NEVER charge 2s and 3s battery together at the same time.
The fuctions of Green LED light under normal operation:
Blinking- Charging
Solid- Fully Charged
Attention:
1 .If indicator light does not shine after connected, check if battery is poor connected or battery voltage lower than 1.5V/CELL. When one cell voltage less than 3V, will start small current repair charge. All green indicator light flashes quickly mean repair is failed and battery damaged. Only all cells voltage up to 3V, battery will move into the high current charging till full charge.
2. When using the same power with several this kind of charger, attention to power supply voltage and power levels.
3. Indicator light will flash and stop charging when input voltage under 10V or over 18V. Charger must be restarted to stop the alarm.